List 3 dmesgコマンドの実行結果
$ dmesg
Linux version 2.2.17-0vl10 (root@neo.dicey.org) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #1 Sat Oct 14 20:57:17 JST 2000
Detected 518341 kHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 418.61 BogoMIPS
Memory: 62672k/65536k available (1328k kernel code, 412k reserved, 1048k data, 76k init)
Dentry hash table entries: 8192 (order 4, 64k)
Buffer cache hash table entries: 65536 (order 6, 256k)
Page cache hash table entries: 16384 (order 4, 64k)
VFS: Diskquotas version dquot_6.4.0 initialized
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: Intel Pentium II (Deschutes) stepping 03
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35a (19990819) Richard Gooch (rgooch@atnf.csiro.au)
PCI: PCI BIOS revision 2.10 entry at 0xfd9de
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Enabling memory for device 00:78
PCI: Enabling memory for device 00:80
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
TCP: Hash tables configured (ehash 65536 bhash 65536)
IPVS: Connection hash table configured (size=4096, memory=32Kbytes)
Initializing RT netlink socket
Starting kswapd v 1.5
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
Detected PS/2 Mouse Port.
Serial driver version 4.27 with MANY_PORTS MULTIPORT SHARE_IRQ enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
ttyS02 at 0x03e8 (irq = 4) is a 16550A
ttyS03 at 0x02e8 (irq = 3) is a 16550A
pty: 256 Unix98 ptys configured
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.13)
Real Time Clock Driver v1.09
RAM disk driver initialized:16 RAM disks of 4096K size
Uniform Multi-Platform E-IDE driver Revision: 6.30
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0x1020-0x1027, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0x1028-0x102f, BIOS settings: hdc:DMA, hdd:pio
hda: IDE Hard Drive, ATA DISK drive
hdc: IDE CDROM Drive, ATAPI CDROM drive
ide2: ports already in use, skipping probe
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: IDE Hard Drive, 1999MB w/2kB Cache, CHS=1015/64/63
hdc: ATAPI 1X CD-ROM drive, 32kB Cache
Uniform CD-ROM driver Revision: 3.11
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
md driver 0.90.0 MAX_MD_DEVS=256, MAX_REAL=12
raid5: measuring checksumming speed
raid5: MMX detected, trying high-speed MMX checksum routines
pII_mmx : 388.239 MB/sec
p5_mmx: 400.050 MB/sec
8regs :1104.138 MB/sec
32regs: 529.590 MB/sec
using fastest function: 8regs (1104.138 MB/sec)
scsi : 0 hosts.
scsi : detected total.
md.c: sizeof(mdp_super_t) = 4096
Partition check:
hda1 hda2 < hda5 hda6 >
autodetecting RAID arrays
autorun ...
... autorun DONE.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 76k freed
usb-uhci.c: $Revision: 1.232 $ time 21:08:34 Oct 14 2000
usb-uhci.c: High bandwidth mode enabled
Adding Swap: 66488k swap-space (priority -1)
pcnet32.c: PCI bios is present, checking for devices...
PCI Master Bit has not been set. Setting...
Found PCnet/PCI at 0x1000, irq 9.
eth0: PCnet/PCI II 79C970A at 0x1000, 00 50 56 81 00 64 assigned IRQ 9.
pcnet32.c:v1.25kf 26.9.1999 tsbogend@alpha.franken.de
mice: PS/2 mouse device common for all mice
usb.c: registered new driver hid